L300 V6-3.0L VIN R (2001)
10. Install suction/liquid line assembly into clamp at front of dash.
11. Install oxygen sensor harness clip onto suction/liquid line assembly.
12. Close steel harness clip and install nut.
Torque:
Nut to Harness Clip: 6 N.m (53 in-lbs)
13. Install suction/liquid line assembly clamp at mount area.
Torque:
Suction Liquid Line Assembly Clamps: 5 N.m (44 in-lbs)
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON THE HOIST. TO HELP
AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE
OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.
