L300 V6-3.0L VIN R (2001)
94. Using a T30 Torx(R) socket, remove both outer beam bolts. Use caution not to damage door paint.
95. Install Cockpit Assembly Aid J 43894 into A-pillar beam bolt holes. Tool flange should fit tight to A-pillar surface when completely installed.
This tool is needed to prevent accidentally dropping a bolt inside A-pillar.
NOTE: Use a T40 Torx(R) socket to prevent stripping bolt.
96. Using a T40 Torx(R) socket, remove both inner beam bolts.
97. Repeat beam bolt removal procedure on passenger's side.
98. Remove cockpit assembly aid (J 43894).
