L300 V6-3.0L VIN R (2001)
7. Remove EVAP canister from fuel tank.
8. Remove pump module.
9. Inspect inlet filter on pump. If plugged or damaged, fuel pump module must be replaced not serviced separately.
10. Flush tank with hot water for at least 6 minutes; invert and drain. All metal chips/debris must be removed from tank prior to installation.
11. Install EVAP canister to fuel tank.
12. Install fuel pump module to fuel tank using new fuel pump seal. Do not connect fuel feed line to new filter.
13. Install fuel tank to vehicle.
NOTE: Replace plastic fuel line retainers whenever fuel supply lines are disconnected at fuel filter and fuel rail. Install new retainer into female
portion of connection. Care must be taken to assure that locking tab is centered in window of female connection. Firmly press male and female
portions together until a "click" is heard, then pull firmly back to confirm engagement.
14. Connect fuel lines to fuel rail.
15. Put at least six gallons of clean fuel into fuel tank.
16. Connect negative battery cable.
17. Connect Scan tool to vehicle and turn ignition On.
18. Raise vehicle on hoist and install male quick connect adapter (from Fuel Flow/Pressure Adapter SA9127E-7 into fuel feed line.
19. Install drain hose to adapter and place other end in an approved container.
20. Energize fuel pump with Scan tool for 1 to 2 minutes. (Refer to "Energizing the Fuel Pump" procedure.) This will pump about two quarts of fuel
and purge any debris in fuel pump.
NOTE: Replace plastic fuel line retainers whenever fuel supply lines are disconnected at fuel filter and fuel rail. Install new retainer into female
portion of connection. Care must be taken to assure that locking tab is centered in window of female connection. Firmly press male and female
portions together until a "click" is heard, then pull firmly back to confirm engagement.
