L300 V6-3.0L VIN R (2001)
38.
Cut Ckt (2000-2001) 485 DK BLU (2002-2003) 485 DK GRN terminal #5 throttle body connector to 152.5 mm (6 in) from connector.
39.
Cut new terminal lead, P/N 22690873, to 152.5 mm (6 in) and insert in terminal location # 5 of throttle body, P/N 22720050.
40.
Repeat above crimping procedure for Ckt 485.
41.
Cut Ckt 487 YEL/BLK terminal # 6 throttle body connector to 152.5 mm (6 in) from connector.
42.
Cut new terminal lead, P/N 22690873, to 152.5 mm (6 in) and insert in terminal location # 6 of throttle body, P/N 22720050.
43.
Repeat above crimping procedure for Ckt 487.
Caution:
DO NOT USE MATCH OR OPEN FLAME TO APPLY HEAT TO SEAL.
44.
Apply heat using a heat gun, or equivalent, and heat to 1 75°C (347°F) until glue flows down around edges of sleeves for each ckt.
45.
Move terminal retainers of new throttle body connector, P/N 22720050, to locked position to secure terminals.
46.
Wrap wires with tape and insert into conduit.
47.
Apply tape to conduit to retain wires.