L300 V6-3.0L VIN R (2001)
24.
Install steering column upper shroud.
Torque:
Steering Column Trim Cover Attaching Fasteners: 4 Nm (35 in-lbs)
25.
Install lock cylinder bezel.
26.
Connect negative battery cable.
Torque:
Battery Terminal Bolt: 17 Nm (13 ft-lbs)
27.
Verify proper function of ignition lock cylinder.
S - Series
IMPORTANT:
The important statement at the beginning of the "Ignition Lock Cylinder removal procedure on page 188 in the 2000/2001 Saturn S-Series
Body/Electrical Volume II Service Manual is incorrect. Please cross out the important on that page and write in the following important statement.
IMPORTANT:
When replacing the ignition lock cylinder only, the passlock relearn procedure is not required.
1.
Disconnect negative battery cable.
2.
Remove lock cylinder bezel from steering column shroud by carefully prying with a thin bladed screwdriver.