L300 V6-3.0L VIN R (2001)
Body Control Module: Removal and Replacement
Body Control Module Replacement
REMOVAL
IMPORTANT: After replacement of BCM, programming is required. See: Testing and Inspection/Programming and Relearning
1. Open glove compartment door.
2. Remove glove compartment lamp assembly by pulling on lamp plunger.
3. Disconnect glove compartment lamp wiring harness from glove compartment lamp.
4. Remove right side UP lower closeout panel (hush panel) retainers.
5. Pull closeout panel (hush panel) rearward to detach from forward retainers.
6. Remove right side heater outlet assembly retainer and remove outlet.
