L300 V6-3.0L VIN R (2001)
6. Remove ignition switch bezel and remove lower cover.
7. Remove SIR coil assembly rosebud-type fastener from bracket below steering column.
8. Disconnect horn/cruise connector under steering column.
9. Remove SIR coil assembly by carefully prying the plastic retainers.
10. Guide SIR coil wiring harness from behind lever control switch and remove SIR coil assembly.
Installation
NOTICE: A new SIR coil assembly is equipped with a yellow tab that is removed after steering wheel is installed. This tab passes through the
steering wheel.
1. Route SIR wiring harness and horn/cruise connector behind turn signal lever combination switch and down steering column.
2. Install SIR coil assembly to turn signal lever combination switch housing.
