L300 V6-3.0L VIN R (2001)
10. Twist together one connector wire lead to one deployment wire. The connection should be mechanically secure.
11. Bend twisted connection, (made in step 10), flat and wrap tightly with electrical tape to insulate and secure.
12. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire as in steps 10 and 11.
13. Connect the deployment harness to the yellow 2-way connector of the inflator module to be deployed.
^
for driver inflator module or passenger inflator module, connect to appropriate connector at base of steering column
^
for the left curtain inflator module or right curtain inflator module, connect to connector under C-pillar trim
14. Stretch deployment harness wires from vehicle to their full length.
15. Verify that vehicle is clear of all people, loose objects, or flammable material.
IMPORTANT: When deploying an inflator module, the rapid expansion of gas is very loud which may startle the uninformed. Notify the people in
the immediate area that an inflator module will be deployed.
16. Separate the two ends of the deployment wires that were twisted together in step 9.
17. Temporarily connect the deployment wires to a 12 volts minimum/2 amps minimum power source to deploy inflator module. A vehicle battery is
suggested. (Inflator module deployment will occur when contact is made.)
CAUTION: IMMEDIATELY FOLLOWING THE DEPLOYMENT OF AN AIR BAG, THE METAL SURFACES OF THE INFLATOR
MODULE ARE VERY HOT. DO NOT PLACE THE DEPLOYED INFLATOR MODULE NEAR ANY FLAMMABLE OBJECTS. WAIT
FOR ABOUT TEN MINUTES BEFORE TOUCHING ANY METAL SURFACE OF THE INFLATOR MODULE. DISREGARDING
THESE PRECAUTIONS MAY CAUSE FIRE OR PERSONAL INJURY.
18. Put on a pair of shop gloves and safety glasses to protect your hands and eyes from possible irritation when handling the deployed inflator module.
19. Dispose of the deployed inflator module through normal refuse channels after it has cooled for at least ten minutes.
20. Wash hands with a mild soap.
