L300 V6-3.0L VIN R (2001)
Brake Switch (Cruise Control): Service and Repair
CRUISE BRAKE SWITCH
REMOVAL
1. Ignition Off.
2. Remove left side lower I/P closeout panel (hush panel) push pin fasteners and remove panel.
3. Remove left side lower heater duct assembly push pin fastener and remove duct.
4. Disconnect cruise brake switch harness connector.
5. Remove cruise brake switch by rotating it 180° so it will pull out from the bracket.
INSTALLATION
NOTE: The notch on the plunger will be fully visible when the plunger is all the way out.