L300 V6-3.0L VIN R (2001)
12. Remove and discard tie rod end nut.
NOTICE: Do not attempt to separate joint using a wedge-type tool because seal may be damaged.
13. Using Tie Rod Separator SA91100C (or equivalent), separate tie rod end from steering knuckle.
NOTICE: Be careful not to allow steering knuckle to contact ball stud seal. Contact may cause the seal to rip, requiring ball stud replacement.
IMPORTANT: Place a cloth over the ball stud boot, protecting it from damage caused by contact with steering knuckle.
14. Remove lower ball stud bolt and nut.
15. Separate lower control arm from knuckle.
