L300 V6-3.0L VIN R (2001)
Front Steering Knuckle: Service and Repair
Assembly
WHEEL BEARING/HUB ASSEMBLY
-
TOOLS REQUIRED
-
J44015 Steering Linkage Installer
-
J44563 Front Wheel Bearing Remover/Installer
-
SA9140E Torque-to-Angle Gauge
1. Press in new bearing as shown in illustration until seated using Front Wheel Bearing Remover/Installer J44563 (or equivalent).
5 - Knuckle support tube
7 - Large driver
2. Install bearing retainer snap ring.
IMPORTANT: When performing this operation, small driver (part number 6) must be used to support bearing inner race with its small (pilot) side
facing towards press, away from bearing.