L300 V6-3.0L VIN R (2001)
12. Install Steering Wheel Puller Bridge J I 859A (or equivalent) and Steering Wheel Puller Legs J42578 (or equivalent).
13. Remove steering wheel while feeding the wiring through the wheel opening.
NOTICE: Always align the front wheels to the straight-ahead position when installation or removing a roll connector.
NOTICE: If yellow tab is not available, use tape to prevent SIR coil from rotating.
14. Insert yellow tab or use a piece of tape to prevent rotating the SIR Coil.
Installation
1. Remove yellow tab or tape from SIR Coil assembly.
2. Route wiring through steering wheel and install steering wheel onto steering shaft noting orientation notch that locates steering wheel in correct
position.
IMPORTANT: A new steering wheel attachment nut must be used.
3. Install new steering wheel attachment nut.
Torque: Steering Wheel Nut: 40 Nm (30 ft. lbs.)
4. Connect cruise control (if equipped) switch connectors and attach harness to wheel.
