L300 V6-3.0L VIN R (2001)
Tie Rod Boot: Service and Repair
STEERING GEAR BOOT
-
TOOLS REQUIRED
-
J44015 Steering Linkage Installer
-
SA91100C Tie Rod Separator
-
SA9164C Clamp Pliers
REMOVAL
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON THE HOIST. TO HELP
AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE
OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Loosen outer tie rod-to-inner tie rod jam nut.
4. Remove tie rod end-to-knuckle nut and discard.
NOTICE: Do not attempt to separate joint using a wedge-type tool because seal may be damaged.
5. Using Tie Rod Separator SA91100C (or equivalent), separate tie rod end from steering knuckle.
6. Unthread outer tie rod from inner tie rod and remove from vehicle.
7. Remove inner tie rod to outer tie rod jam nut.
