L300 V6-3.0L VIN R (2001)
8. Remove boot clamp on tie rod end.
9. Remove boot clamp on steering gear housing end with cutters and discard.
10. Remove steering gear boot from steering gear.
INSTALLATION
1. Install new boot clamp onto steering gear boot at steering gear housing end.
2. Apply grease in service kit to locations shown in illustration prior to boot installation. This grease provides a water barrier and must be used to
protect internal gear components from corrosion.
3. Install boot onto inner tie rod assembly. Slide boot along rod assembly until large end of boot is seated i steering gear housing groove.
4. Using Clamp Pliers SA9164C, crimp clamp on housing end of boot.
5. Install clamp on inner tie rod end of boot.
