L300 V6-3.0L VIN R (2001)
8. With the aid of an assistant, remove the window assembly.
Installation Procedure
Important: Loose material and/or a rough surface on the remaining urethane may cause sealing problems during installation of the
window assembly.
1. Remove the old urethane with a razor knife leaving a thin film, approximately 1-2 mm (0.04-0.08 in) around the perimeter of the window opening
and the window assembly, if being reused.
2. Clean the entire window opening and glass bonding surfaces with a clean, lint-free, alcohol-dampened cloth. Allow to air dry.
3. Install the molding around the perimeter of the glass.
Important: If the applied molding becomes loose from the edge of the glass, clear and black prime the affected area. Allow to air dry.
Apply a thin bead of urethane and install the molding.
4. Replace the molding if damaged or excessively stretched.
