L Series V6-3.0L VIN R (2004)
9. Install the assist handle assembly.
Tighten the fasteners to 16 Nm (12 lb ft).
10. Connect the electrical harness at the liftgate.
11. On vehicles equipped with OnStar(R), perform the following procedure:
1. Route and attach the wiring harness from the headliner to the module.
2. Make connections at the OnStar(R) module and body harness located under the right seat bolster.
3. Install the front load floor.
12. Install the right rear seat bolster. Refer to Seat Back Replacement - Rear Split Folding (Sedan) (See: Seats/Seat Back/Service and
Repair/Removal and Replacement/Seat Back Replacement - Rear Split Folding (Sedan))Seat Back Replacement - Rear Split Folding (Wagon) (
See: Seats/Seat Back/Service and Repair/Removal and Replacement/Seat Back Replacement - Rear Split Folding (Wagon)).
13. Install the garnish molding to the rear upper corner. Refer to Garnish Molding Replacement - Rear Corner Upper (See: Trim Panel/Service and
Repair/Garnish Molding Replacement - Rear Corner Upper).