L Series V6-3.0L VIN R (2004)
1. Lightly coat the new seals, including the O-rings, with engine oil prior to installation to assist in holding the O-ring seals to the camshaft cover.
2. Install the camshaft cover seals.
3. Apply a thin coat of LOCTITE 5900 or equivalent on the front and rear of the camshaft cover as shown in the figure as the shaded areas.
4. Install the camshaft cover to the cylinder head.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the camshaft cover bolts.
^
Tighten the camshaft cover bolts to 8 Nm (71 inch lbs.).
6. Install the oil filler cap.
7. Install the lift bracket.
^
Tighten the engine lift bracket bolts to 8 Nm (71 inch lbs.).
8. Install the ignition module.