LS2 V6-3.0L VIN R (2000)
1. Slide regulator assembly through the opening in the lower center door reinforcement.
2. Install and snug regulator attachment bolts.
3. Install rear most regulator attachment bolt and leave loose to allow window installation.
4. Install door glass.
5. Tighten all regulator bolts.
6. Connect electrical connector to regulator (power windows only).
IMPORTANT: Replace water deflector if damaged.
7. Install water deflector.
8. In stall trim panel.
9. Operate window to up and down position to check operation. If binding exists, inspect all weatherstrips and adjust as necessary.
