LS2 V6-3.0L VIN R (2000)
1. Slide the regulator assembly through the opening in the lower center door reinforcement.
2. Install and snug regulator attachment bolts.
3. Install the rear most regulator attachment bolt and leave loose to allow window installation.
4. Install the door glass. Refer to Window - Front Door Installation.
5. Tighten all the regulator bolts.
6. Connect the electrical connector to regulator, power windows only.
7. Replace the water deflector if damaged.
8. Install the water deflector.
9. Install the trim panel. Refer to Door Trim Panel - Front Installation.
10. Operate window to up and down position to check operation. If binding exists, inspect all weather-strips and adjust as necessary.
