LS2 V6-3.0L VIN R (2000)
IMPORTANT:
Cable clip must be installed to the decklid inner sheet metal panel in a location that Will allow clip to fully seat in the space between inner and outer
decklid sheet metal.
26.
Mark a position on decklid inner panel that will allow cable clip to fully seat in decklid sheet metal. Position release handle cable clip as close as
possible to center of cable.
NOTICE:
If drill bit is allowed to drill into sheet metal at a depth greater than 6.5 mm (1/4 in.), outer surface of exterior panel may be penetrated.
27.
Center-punch and drill 6.5 mm (1/4 in.) hole at mark on inner panel.
28.
Apply 3M(R) WINDO-WELD Primer (P/N 08643) or equivalent to bare metal edges of hole.
29.
Install release handle cable and cable clip to decklid.
Trap-Resistant Latch & Interior Rel. Handle Electrical Install.
2000 S-Series Coupes and Sedans
1.
Wrap entire length of handle wiring harness with tape to prevent damage to wires.
2.
Route handle wires along existing decklid harness over to bottom of decklid hinge.
3.
Insert handle wires into existing clips along decklid harness.