LS2 V6-3.0L VIN R (2000)
21.
Apply Loctite 242 Threadlocker, or equivalent to front seat attachment bolts.
22.
Install left front seat.
Torque: 25 Nm (19 ft-lbs)
23.
Route BLK and WHT handle wires over to decklid latch area.
24.
Remove conduit on existing decklid wiring harness.
IMPORTANT:
After cutting decklid latch harness it will be necessary to splice three wires (two existing vehicle wires and one new handle wire) into each crimp and
seal splice sleeve.
25.
Splice handle WHT wire to decklid latch harness RED/BLK wire using splice sleeve supplied with kit.
26.
Splice handle BLK wire to decklid latch harness BLK wire using splice sleeve supplied with kit.
27.
Install conduit onto decklid harness and BLK and WHT handle wires.
28.
Connect decklid harness to latch assembly.
