LS2 V6-3.0L VIN R (2000)
Cross-Member: Service and Repair
-
TOOLS REQUIRED
-
SA9140E-Torque Angle Gauge
REMOVAL
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID
PERSONAL INJURY, PROVIDE SUPPORT TO THE OPPOSITE END OF THE VEHICLE THAT COMPONENTS WILL BE
REMOVED FROM.
1. Raise vehicle on hoist.
2. Remove rear wheel and tire assemblies.
3. Remove rear exhaust system from resonator back.
4. Remove heat shield form rear suspension support.
5. Remove upper and lower control arm to rear axle control arm attachment bolts, discard bolts and nuts.
