LS2 V6-3.0L VIN R (2000)
DISCLAIMER
Procedure
1.
Inspect headliner at rear of sunroof opening to verify customer concern.
IMPORTANT:
If necessary, perform procedure in Technical Bulletin 99-T-69B to correct rattle noises in headliner area before performing the following procedure.
2.
Remove dome lamp lens cover by pulling down gently.
3.
Remove reading and dome light bulbs from dome lamp assembly.
4.
Remove dome lamp assembly by prying retaining tabs upward and inward.
5.
Disconnect dome lamp wiring harness connector and remove dome lamp.
IMPORTANT:
It is critical that hook-and-loop material is installed properly to ensure proper positioning and alignment of dome lamp to sunroof module. At front of
dome lamp assembly at location (1), only the piece of loop material is required. At rear of dome lamp assembly at location (2), both of the
hook-and-loop pieces are required.
