LS2 V6-3.0L VIN R (2000)
10.
Using a flat blade screwdriver, gently pry upward to disengage attaching clips, while pushing switch out of valance.
11.
Snap new power seat switch into outer valance. Refer to Parts Requirements section in this bulletin for specific part information.
12.
Connect switch harness to switch.
13.
Position valance to seat adjuster, then slide valance rearward to lock valance into seat adjuster tongue.
14.
Install valance fasteners.
Torque:
Outer Seat Valance Fasteners: 2.5 N.m (22 in-lbs)
15.
Position seat into vehicle.
16.
Tilt seat rearward and connect seat wiring harnesses.
17.
Slide seat forward into tracks.
18.
Apply Loctite(R) 242 Threadlocker (or equivalent) to seat fasteners and install seat fasteners.
Torque:
Seat Fasteners: 25 N.m (19 ft-lbs)
CAUTION:
APPLY LOCTITE 242(R) (OR EQUIVALENT) ON ALL RESTRAINT FASTENERS PRIOR TO INSTALLATION.
