LS2 V6-3.0L VIN R (2000)
If the spoiler holes are located in the rear compartment lid, start with Step 11.
Important: If installing the spoiler on a replacement rear compartment lid, use the proper Saturn template to ensure that the holes in the
rear compartment lid are properly placed.
1. Place a prop rod under the rear compartment lid that will safely support the lid.
2. Move the compartment support springs from location (1) to location (2) as shown in the illustration.
3. Remove the prop rod and close the rear compartment.
4. Measure (a) 254 mm (10 in) from the leading edge of the rear compartment lid, and place the template on the rear of the compartment lid as shown
in the illustration.
Hold down the template with an automotive grade masking tape, or similar temporary adhesive.
5. Locate the 5 holes to be drilled in the rear compartment lid on the template. Lightly mark the holes with a center punch and hammer.
Make one small indentation for each hole to be drilled.
6. Remove the template from the rear compartment lid.
7. Drill the center hole 7 mm (9/32 in).
8. Drill the 2 middle holes 20 mm (13/16 in) using either a hole cutter or a drill bit.
