LS2 V6-3.0L VIN R (2000)
3. Remove piston seal from groove in caliper.
4. Remove bleeder valve and bleeder valve cap from caliper body.
5. Clean all parts in clean denatured alcohol. Dry with non-lubricated, low pressure, compressed air. Make sure to blow out all passages in caliper
body and bleeder valve.
6. Inspect piston for scoring, nicks, cracks, wear or corrosion. Replace piston if any damage is found.
7. Inspect caliper body piston bore for scoring, nicks, wear, or corrosion. Crocus cloth can be used to remove light corrosion. If more extensive
damage is present, replace caliper.
IMPORTANT: Do not hone caliper bore.
8. Inspect seal groove in caliper bore for nicks or burrs. If present, replace caliper.
ASSEMBLY
1. Install bleeder valve into caliper body assembly.
Torque: 6 Nm (53 inch lbs.)
