LS2 V6-3.0L VIN R (2000)
5. Remove master cylinder.
INSTALLATION
1. Position master cylinder onto booster studs and install nuts.
Torque: 25 Nm (18 ft. lbs.)
NOTICE: Be careful not to bend brake pipes.
2. Position brake pipes into master cylinder and tighten nuts.
Torque: 18 Nm (13 ft. lbs.)
3. Vehicles equipped with manual transaxles must install clutch hydraulic feed line to master cylinder.
4. Connect low brake fluid sensor electrical connector.
5. Fill brake fluid reservoir with clean brake fluid up to "MAX" mark on reservoir.
6. Bleed brake system.