LS2 V6-3.0L VIN R (2000)
NOTICE:
It may be necessary to reconnect battery and activate wipers so the blower motor housing will clear the wiper linkage.
12.
Remove blower motor assembly by lifting straight out.
13.
Obtain new replacement blower motor assembly (P/N 24427572).
14.
Install new blower motor assembly into module housing. Fan motor assembly rib must be located into channel in module housing.
15.
Connect blower motor electrical connector.
16.
Install blower motor housing. Housing rib must fit into slot in module case. Snap left and right clip into place and install fan housing to module
screws.
Torque:
Fan Housing-to-Blower Motor Housing
Screws: 1 Nm (9 in-lbs)
NOTICE:
A new filter housing seal must be used whenever the filter housing is removed to prevent water from leaking into the HVAC module.
17.
Remove filter housing seal using a small flat blade screwdriver.
18.
Install new filter housing seal (P/N 09179222).
19.
Install passenger compartment air filter housing and screws.
