saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Emissions - SES Lamp ON/DTC's Set After Cold Start-Up|Page 11219 > < Windows - Fogging In High Humidity Conditions|Page 11213
Page 1
background image

PCV Valve Hose: All Technical Service Bulletins
Emissions - SES Lamp ON/DTC's Set After Cold Start-Up

Bulletin No.: 04-06-04-085

Date: November 22, 2004

TECHNICAL

Subject:
Service Engine Soon (SES) and/or Reduced Power Lamp Illuminating Following Cold Engine Start Up In Subfreezing Temperatures, Diagnostic
Trouble Codes (DTC) P0638, P1510 and/or P1516 Stored in Engine Control Module (ECM) (Re-locate Small Primary Positive Crankcase Ventilation [
PCV] Hose)

Models:
2000-2005 Saturn L-Series Vehicles with 3.0L V-6 Engine (VIN R - RPO L81)

Attention:

Fixed Operations Manager and Technician

Condition

Some customers may comment on the Service Engine Soon (SES) and/or Reduced Power lamp illuminating and limited throttle response immediately
following cold engine start up during subfreezing temperatures. Diagnostic trouble codes (DTC) P0638 or P1510 and/or P1516 may be stored in the
engine control module (ECM).

Cause

This condition may be caused by crankcase vapors inside the throttle body collecting at the throttle plate base as engine cools down while shut off,
resulting in restricted throttle plate movement immediately following cold engine start up during subfreezing temperatures.

Correction

Re-locate primary positive crankcase ventilation (PCV) hose from throttle body to intake manifold upper plenum. Refer to service procedure in this
bulletin.

Service Procedure

Caution:

Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being
done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.

Caution:

Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless
instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also
disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its
components.

1.

Disconnect negative battery cable.

1.1.

Record all of the customer's radio station presets.

1.2.

Turn off all the lamps and accessories.

1.3.

Make sure the ignition switch is in the OFF position.

1.4.

Remove the battery ground (negative) cable and bolt from the battery.

Emissions - SES Lamp ON/DTC's Set After Cold Start-Up|Page 11219 > < Windows - Fogging In High Humidity Conditions|Page 11213