LS2 V6-3.0L VIN R (2000)
Torque: 5 N.m (44 in-lbs)
3. Place thrust bearing and drive plate installer SA9149AC-3 on installation bolt and insert through center of pulley. Thread installation bolt into end
of A/C compressor shaft and hand tighten.
4. Hand tighten nut on installation bolt to align pulley to A/C compressor. While holding end of bolt, tighten nut until pulley bottoms out on A/C
compressor.
5. Loosen nut and remove pulley installation bolt.
6. Install snap ring with tapered side out using snap ring pliers.
