LS2 V6-3.0L VIN R (2000)
16. Slide upper pusher fan shroud under retaining tabs located at upper edge of condenser.
17. Rotate lower fan shroud onto lower mounting studs and install retaining nuts.
Torque: 5 N.m (44 in-lbs)
NOTE: Position pusher fan electrical harness in shroud indentation to prevent harness damage.
18. Route pusher fan electrical harness around outside of radiator end tank, below upper radiator hose.
19. Lower vehicle.
20. Remove liquid/suction line assembly and liquid line caps and install new seal washer.
21. Install liquid line to liquid/suction line assembly and hand start nut.
Torque: 12 N.m (106 in-lbs)
22. Install liquid line into rail clamp.
