LS2 V6-3.0L VIN R (2000)
1. Remove rear axle control arm bolts and discard.
NOTICE: Use new bolts; torque retention of old bolts may not be sufficient.
IMPORTANT: Do not tighten bolts at this time.
2. Install new bolts leaving the inside forward bolt out.
3. Install rear toe adjusting tool KM-900 into the open bolt hole.
4. Using rear toe adjusting tool KM-9OU, move rear axle control arm in the direction of necessary toe correction.
5. Snug rear axle control arm bolts, do not tighten to final torque at this time.
6. Recheck toe and adjust if necessary.