LS2 V6-3.0L VIN R (2000)
9.
Install plastic fuel tank grounding strap attachment nut to stud located near fuel filter.
Torque: 4.5 Nm (40 in-lbs)
10.
Install rear heat shield and retaining bolts.
Torque: 7 Nm (62 in-lbs)
11.
Install exhaust system intermediate pipe (with muffler).
Torque: 20 Nm (15 ft-lbs)
12.
Lower vehicle.
13.
Add fuel to fuel tank.
14.
Connect negative battery cable.
Torque: 17 Nm (13 ft-lbs)
15.
Prime fuel system.
a.
Using ignition, cycle switch On for 5 seconds and then Off for 10 seconds. Repeat this twice.
b.
Examine fuel lines for leaks.
c.
Crank engine until it starts (allowing a maximum of 15 seconds of cranking time).
16.
Affix Campaign Completion Label on a clean and dry surface of radiator core support, in an area clearly visible when hood is raised. (For more
information, refer to "Campaign Completion Label" in this bulletin.)
Campaign Completion Label
