LS2 V6-3.0L VIN R (2000)
32.
Cut Ckt 582 BRN terminal # 4 throttle body connector 127 mm (5 in) from connector.
33.
Cut new terminal lead, P/N 22690873 to 127 mm (5 in) and insert terminal location # 4 of throttle body connector, P/N 22720050.
34.
Repeat above crimping procedure for Ckt 582.
35.
Cut Ckt 2752 BLK terminal # 2 throttle body connector 254 mm (10 in) from connector.
36.
Cut new terminal lead, P/N 22690873, to 254 mm (10 in) and insert in terminal location # 2 of throttle body connector, P/N 22720050.
37.
Repeat above crimping procedure for Ckt 2752.
38.
Cut Ckt 2701 GRA terminal # 3 throttle body connector 304 mm (12 in) from connector.
39.
Cut new terminal lead, P/N 22690873, to 304 mm (12 in) and insert in terminal location # 3 of throttle body connector, P/N 22720050.
40.
Repeat above crimping procedure for Ckt 2701.
41.
Cut Ckt 486 PPL terminal # 5 throttle body connector 355.6 mm (14 in) from connector.
42.
Cut new terminal lead, P/N 22690873, to 355.6 mm (14 in) and insert in terminal location # 5 of throttle body connector, P/N 22720050.
43.
Repeat above crimping procedure for Ckt 486.
44.
Cut Ckt 485 DK GRN terminal # 6 throttle body connector 406.4 mm (16 in) from connector.
45.
Cut new terminal lead, P/N 22690873, to 406.4 mm (14 in) and insert in terminal location # 6 of throttle body connector, P/N 22720050.
46.
Repeat above crimping procedure for Ckt 485.
Caution:
DO NOT USE MATCH OR OPEN FLAME TO APPLY HEAT TO SEAL.