LS2 V6-3.0L VIN R (2000)
3. Remove inflator module from vehicle.
4. Temporarily place the inflator module on a work bench or other surface away from all loose or flammable objects and with its vinyl trim cover
facing up.
5. Select a paved outdoor location to perform deployment. Make certain that no loose objects or flammable material are within 4.6 M (15 ft.) of the
inflator module.
6. Place inflator module on the ground with the vinyl trim cover facing up.
7. Stretch the universal deployment harness and harness adapter from inflator module to its full length.
8. Place a power source near the shorted end of deployment harness. (Recommended application:12 Volts minimum, 2 Amps minimum. A vehicle
battery is suggested.)
9. Connect the SIR inflator module to harness adapter on universal deployment harness.
IMPORTANT: Make sure that harness adapter connector is fully seated into inflator module connector. Failure to fully seat connectors may leave
the shorting bar located in the inflator module connector active and may result in non-deployment of inflator module.