LS2 V6-3.0L VIN R (2000)
Notice
Do NOT apply additional Threadlocker to the safety belt buckle attachment fastener. The new fastener comes with Threadlocker already
applied.
5.
Position the replacement rear safety belt buckle assembly into the vehicle with the locating tab facing downward in the positioning slot. Install the
fastener.
Tighten
Tighten the safety belt buckle assembly fastener to 35 Nm (26 lb ft).
6.
Position the rear seat.
7.
Route the rear safety belt buckles through the seat cushion openings.
8.
Snap the rear seat cushion into the attaching retainers.
9.
Lift up on the seat cushion to ensure proper installation.
10.
Verify proper operation of the rear safety belt buckles by latching and unlatching each shoulder belt and lap belt.
Important
Do NOT cover any existing underhood labels when affixing the Campaign Completion Label.
11.
Affix the Campaign Completion Label on a clean and dry surface of the radiator core 5uppOrt, in an area clearly visible when the hood is raised.
Refer to Campaign Completion Label in this bulletin.
