LS2 V6-3.0L VIN R (2000)
7. Remove oil feed pipe assembly bolts, and remove assembly.
8. Remove low and reverse band oil pipe assembly seals.
INSTALLATION
1. Inspect oil feed pipes for plugged passages, bent pipes or cracks.
2. Inspect oil feed pipe seal rings in order to verify proper location of seal rings.
IMPORTANT: The oil feed pipe seals are glued into place during initial assembly. If a seal ring is to be replaced, be sure to thoroughly clean any
residual glue from the feed pipes.
3. Replace seal rings only if they are cut, swelled, or damaged.
4. Install oil feed pipe assembly.
5. Hand start oil feed pipe assembly bolts.
Torque: 12 Nm (9 ft. lbs.)