LS2 V6-3.0L VIN R (2000)
4. Tighten steering knuckle to strut assembly fasteners in the following sequence.
Torque: 50 Nm (40 ft. lbs.), then tighten to 90 Nm (65 ft. lbs.) + 45 degrees
5. Tighten ball stud fastener.
Torque: 100 Nm (75 ft. lbs.)
IMPORTANT: Tie rod ends must be thoroughly cleaned before tightening nut.
6. Using linkage installer J44015 (or equivalent) install the tie rod end into the steering knuckle.
Torque: 45 Nm (35 ft. lbs.)
NOTICE: Use new nut; Torque retention of old nut may not be sufficient.
7. Remove the linkage installer and install a new nut.
Torque: 60 Nm (45 ft. lbs.)
