LS2 V6-3.0L VIN R (2000)
12. Install stabilizer bar link to strut assembly.
Torque: 65 Nm (50 ft. lbs.)
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
13. Position wheel onto hub.
14. Tighten in a crisscross pattern Repeat tightening pattern to make sure torque is correct
Torque: 125 Nm (92 ft. lbs.)
15. Lower vehicle from hoist.
16. Depress brake pedal and tighten axle to hub nut in the following sequence:
Torque: Nut to 115 Nm (85 ft. lbs.) to seat the bearing back nut off and retighten to 20 Nm (15 ft. lbs.) using a torque angle gauge turn nut
additional 90 degrees. If required, release nut until a cotter hole aligns with castle nut slot.
17. Install cotter
18. Perform vehicle wheel alignment. (Refer to "Wheel Alignment" procedure.)
