LS2 V6-3.0L VIN R (2000)
4. Remove the molding around the rear window carefully; try not to excessively stretch it.
5. Remove the electrical connectors from the rear window defogger bus bars. Locate the electrical connectors and mark the location both inside and
outside of the window with tape so as not to damage the wiring/connectors when using the power glass removal tool.
Caution: When using power tools that may create smoke when cutting urethane sealant, work should be done in a well ventilated area and/or with
a NIOSH/MSHA Approved air supplied respirator to prevent possible harmful exposure.
When the urethane adhesive is heated enough to give off smoke, high levels of methylene diisocyanate (MDI) may be present.
Unprotected exposure to methylene diisocyanate (MDI) may result in severe, chronic, debilitating respiratory problems.
Notice: Care must be taken not to damage the roof when using power glass removal tool.
6. With the power glass removal tool, cut the urethane seal along the roof, down the sides, and along the package shelf between the decklid hinges
from inside of the vehicle.
7. Use piano wire to cut the urethane at the lower corners. Feed the wire under the glass at the C-pillar through the inside and back out at the package
shelf, then around the outside of the bead. Use a sawing motion to cut the urethane.
8. With the aid of a helper, remove the window assembly.
Installation Procedure
