LS2 V6-3.0L VIN R (2000)
Important: Loose material and/or a rough surface on the remaining urethane may cause sealing problems during installation of the
window assembly.
1. Remove the old urethane with a razor knife leaving a thin film, approximately 1-2 mm (0.04-0.08 in) around the perimeter of the window opening
and the window assembly, if being reused.
2. Clean the entire window opening and the glass bonding surfaces with a clean, lint-free, alcohol dampened cloth. Allow it to air dry.
3. Install the molding around the perimeter of the glass.
Important: If the applied molding becomes loose from the edge of the glass, clear and black prime the affected area. Allow it to air dry.
Apply a thin bead of urethane and install the molding.
4. Replace the molding if damaged or excessively stretched.
Notice: To prevent corrosion, paint damage around the window opening by the power glass removal tool must be covered with pinchweld primer.
Do not prime over existing urethane. Follow manufacturers recommendations for drying time.
Important: Shake the glass prep primer, Clear #1, well before using.
5. For a new window assembly only, apply the glass prep primer, Clear #1, around the entire perimeter of the glass using a dauber. Wipe dry with a
