LW100 L4-2.2L VIN F (2002)
Door Lock Cylinder: Removal and Replacement
Door Lock Cylinder Replacement
Removal Procedure
1. Ensure the window is in the full-up position.
2. Remove the outer door panel. Refer to Outer Door Panel Replacement Rear - Bolt On (See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Panel/Service and Repair/Panel Replacement/Outer Door Panel Replacement Rear - Bolt On) removal.
3. Remove the door sound deadener at the rear.
4. Remove the lock rod from the latch mechanism.
5. Remove the clip and lock cylinder.
Installation Procedure
1. Install the lock cylinder and clip.
Important: The lock rod retainers used in the door lock levers and mechanisms are not re-usable. The retention characteristics are