LW100 L4-2.2L VIN F (2002)
8. Remove fuel level sender card by depressing locking tab and sliding the card up (toward fuel pump cover).
INSTALLATION
1. Slide new sender unit into place until click is beard. (Pulling up lightly to ensure sender unit is locked into place.)
IMPORTANT: Verify that float arm on sender unit maintains correct relationship to pump module by standing module on a flat, horizontal surface.
The float should lay on the surface.
2. Connect electrical connections.
IMPORTANT: The fuel pump module to tank seal must always be replaced whenever module is removed from fuel tank.
3. Install pump module and lock ring using a new tank seal.
4. Reconnect fuel lines & electrical connectors to fuel pump.
5. Install fuel tank.
