LW100 L4-2.2L VIN F (2002)
C.
Route seat belts through rear seat cushion opening and lift rear seat cushion out of vehicle.
2.
Remove passenger's side rear folding seat back.
^
Push up on seat back foam with your hand to expose seat bracket outer retainer.
A.
Unlatch rear seat back. Leave seat in upward position.
Notice:
Rear seat back attachments have an "Easyload" outer bracket that allows the rear seat back to snap into position upon installation. It is
necessary to pry on the bottom of the bracket (where the large pivot pin goes into the seat bracket) to disengage the rear seat back attachment.
B.
Gently pry on the bottom of the bracket (1) while pulling upward on the seat back to disengage outer bracket from pivot pin (2).
C.
Tilt seat back down to align inner pivot tabs then pull seat back outward to remove seat back.
3.
Remove buckle/latch assembly, fiber retainer, seat belt bolt, child seat anchor plate assembly bolts, and install the rear seat center belt anchor
reinforcement plate (part of kit, P/N 15810645).
^
Remove 11.11 mm (7/16 in) seat belt bolt and fiber retainer (if applicable) from the buckle/latch assembly. Save this bolt for reassembly.
A.
Remove the two 8 mm (0.315 in) bolts from the child seat anchor plate assembly. Save these bolts for reassembly.
B.
Slide the rear seat center belt anchor reinforcement plate (part of kit, P/N 15810645) under the child seat anchor plate assembly.
Caution:
APPLY LOCTITE 242 THREADLOCKER(R) (OR EQUIVALENT) ON 8 MM (0.315 in) BOLTS BEFORE INSTALLATION.
C.
Install the two 8 mm (0.315 in) child seat anchor plate assembly bolts at the pivot bracket. Use the two 8 mm (0.315 in) bolts removed in
step 3.2.
Tighten
Tighten child seat anchor plate assembly bolts to 25 +/- 5 Nm (18 lb-ft +/- [44 in-lbs]).
