LW100 L4-2.2L VIN F (2002)
13. Remove remaining rear transaxle mount-to-frame bolts.
14. Remove rear transaxle mount.
NOTICE: Hold ball stud from turning when removing nut. The boot can become torn and damaged if the ball stud turns.
15. Remove tie rod end torque prevailing nuts and discard nuts.
NOTICE: Do not attempt to separate joint using a wedge-type tool because seal may be damaged.
16. Using Tie Rod Separator SA91100C (or equivalent), separate tie rod end from steering knuckle.
17. Remove cradle to shifter link pivot pin clip on vehicles equipped with L61 engine and manual transaxle.
