LW2 V6-3.0L VIN R (2000)
in the door handle mounting plate as shown in Figure A.
If the reinforcement ribs are present as shown in the Figure A, the inside door handle does not require replacement. Install power door lock switch
(or cover on non-power door lock vehicles).
^
If the ribs are not present as shown in Figure B, continue to "Front Inside Door Handle Replacement" procedure in this bulletin for inner door
handle replacement.
3.
Affix Campaign Completion Label on a clean and dry surface of radiator core support, in an area clearly visible when hood is raised. (For more
information, refer to "CAMPAIGN COMPLETION LABEL" in this bulletin.)
Front Inside Door Handle Replacement
1.
Starting at the top, pull on door handle grip to disengage grip from handle and expose door handle fastener.
2.
On power equipped vehicle, disconnect power door lock switch wiring harness and remove switch.
3.
Using a small flat blade screwdriver, gently pry on tweeter speaker cover to remove speaker cover and expose attaching fastener.
4.
On driver's side, using a small flat blade tool, disengage power mirror switch (or cover on non-power mirror vehicles).
5.
On driver's side with power mirrors, disconnect power mirror switch connector and remove power mirror switch.
