LW2 V6-3.0L VIN R (2000)
4. Remove the shoulder belt upper fasteners.
Important: When upper and lower moldings are removed, new snap in clips must be used.
Important: Upper and lower moldings should remain attached to each other and the shoulder belt height adjuster should remain
attached to the upper molding.
5. Starting at the top, pull gently on the center pillar upper molding to disengage the attaching clips. Continue until the upper molding is removed and
the upper portion on the center pillar lower molding is detached from the vehicle.
6. Using a small flat-blade tool to bend the tabs and unhook the upper molding from the lower molding.
