LW2 V6-3.0L VIN R (2000)
IMPORTANT:
When using the salmon splice sleeve with 0.35 mm (22 gage) wire, remove 19 mm (3/4 in.) of insulation. Bend the stripped portion in half to double
the thickness of the wire going into the splice sleeve. Twist the stripped, doubled wire and insert into the splice sleeve.
4.2
Determine proper sleeve for gage of wire. Position stripped ends in sleeve until wires hit stop.
IMPORTANT:
When splicing three wire ends into one splice sleeve, insert both wires into one end; one cut wire end from vehicle harness and new splice wire end
into one side of the splice sleeve until wires hit stop. Hand crimp using approved crimping tool. Insert remaining cut wire end from vehicle harness
into other side of splice sleeve and crimp.
4.3
Hand crimp sleeve using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat for shrinking to
them.
4.4
Check for continuity in the wire.
CAUTION:
DO NOT USE A MATCH OR OPEN FLAME TO APPLY HEAT TO SPLICE SLEEVE.
