LW2 V6-3.0L VIN R (2000)
1. Reach down into the outer corner of the rear seat cushion to expose the bolster retaining tab.
2. Bend the tab upward.
3. Remove the seat bolster:
1. Remove the lower end of the bolster.
2. Push upward to remove the top end of the bolster.
Installation Procedure
Important: Verify that the rear seat shoulder belt is not caught behind bolster when installing the bolster.
1. Position the seat bolster onto the upper bolster attachment.
2. Push down on the bolster to engage the upper attachment and install over the retaining tab.
3. Bend the lower retaining tab over the bolster wire frame at the seat cushion location.
Seat Back Recliner Handle Replacement
Seat Back Recliner Handle Replacement
Removal Procedure
1. Pull on the recliner handle cover to disengage the attaching clips.
2. Move the cover rearward to disengage the locking feature and remove the cover.
3. Remove the recliner handle retainer and remove the handle.
Installation Procedure
1.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
