LW2 V6-3.0L VIN R (2000)
8.
Water test area to verify the repair.
9.
Install carpet. (Refer to "Front Floor Carpet" installation procedure in the Interior Trim section of the 2000 - 2001 or 2002 L-Series
Body/Electrical Volume II Service Manual.)
PASSENGER COMPARTMENT - OUTSIDE
REAR VIEW MIRROR MOUNTING
PANEL-TO-DOOR SEAL (SEDAN AND
WAGON)
1.
Remove front door mirror inner trim panel by pulling on panel to disengage attaching clips.
Note:
Right side shown left side similar.
2.
Apply water to mirror mounting panel tipper edge and inspect for water entry at mirror fastener access hole locations.
3.
Remove outside rear view mirror. (Refer to "Outside Rear View Mirror" removal procedure in the Doors/Windows/Mirrors Section of the 2000
2001 or 2002 L-Series Body/Electrical Volume I Service Manual.)
4.
Remove foam material from upper edge of mirror mounting panel.
5.
Apply KENT Industries Clear Transfer Adhesive two sided tape (P/N 32735) or equivalent, on the back side at the upper edge of the mirror
mounting panel. The tape should run the length of the foam pad contact area and be trimmed to fit around the upper alignment pin.
